Wattson Anywhere or energyhive hub?

A question about : Wattson Anywhere or energyhive hub?

Simple question... Wattson Solar Plus on its way, so do I spend Ј50 on the Wattson Anywhere or Ј30 on the energyhive hub?
Both look the same to me, and energyhive does work with the Wattson transmitter.
Why the price difference? Both link to energyhive's website to show the statistical data too from what I can tell at Wattson's live demo page.

Best answers:

• Wattson adding their mark up!
  I found energyhive very helpful when I dealt with them last year.
  I'd got an old current cost monitor, and so bought an energyhive hub, but it couldn't deal with my diverter.
  Energyhive swapped it for just postage costs when I acquired my Wattson.
  But Wattson doesn't accurately measure diversion either, and reports erroneous readings! Bears no resemblance to my gen meter!!
  Unless I've not set it up properly?
• Buy through the energyhive hub and in the buying process there is an option to tell them you have a wattson - you must do this. Ј30 and you get a wattson compatible hub & they email you the link to the wattson dashboard account setup page.
  This is exactly the way I went about it anyway.
• Went for the Anywhere... and now it's an obsession!
  Seems I have an errant device sucking juice according to the import figure (approx. 500w), my background usage is roughly 200-220w or so.
  From around 12.30 am, import gradually rose to it's current level.
  Has anyone with a Wattson seen this before? Worth resetting the transmitter? It's being powered by batteries as no electric socket nearby)
• I've not seen this... sometimes I see small discrepancies of about 50W e.g. more power being diverted than is left after base load... but it's not clear because I don't know whether the figures you see are averages over the past few seconds or instantaneous readings.
  Could try shutting down RCDs until you find what's causing it?
• Dodgy transmitter!
  Turned off all breakers and the main switch in consumer unit and Wattson was still reporting 318.
  Pulled out cable for clamp round the mains feed from the transmitter ... *still* thought I was generating!
  Took out batteries for a short while and back to normal. Will be logging a ticket with them
• I'd read about poor usage with batteries on the most frequent update setting, so have set that to the lowest (12 secs I think it is).
  All my gubbins (meter, henley box, etc) are outside in a wall box, so no leccy socket nearby (I know you can get extension cables for the clamps, but I'm not doing any wall drilling where there are that many electric cables... grid ones included!!)
  Quite odd, really, as I unplugged the solar generation cable from transmitter and Wattson displayed zero , which I expected.
  Was not expecting it to still report usage when I'd turned the breakers off and unplugged the clamp cable!